post up your photos. especially those in open engine compartments. i don't know why, but can i request a shot showing a pair of F100 fenderwell headers in a fenderless model A?
did you make those jeff? it's real similiar to what i have in mind. i have the flamethrower but i might end up chroming mine. i'm running two more strombergs. i'm even painting the engine gold although it's a brighter, shinier gold. @titus
i need that CAD software for my computer. it's always nice to go to the man with nice, detailed drawings. i remember a pair similiar to yours except the dumps ran higher, sort of in line with what a lakes header would be. like these only different.
nice if they fit inside the frame rail for under car exhaust. i haven't ruled out truck manifolds either. i was looking at extrude honing a pair of truck manifolds when i found out how much that cost.
Check out these headers made by Nathan Stewart and his dad for his Model A coupe. Scroll down about half way on this page and the pictures will start. https://www.jalopyjournal.com/forum...coupe-y-block-build-father-son.1004188/page-5
Matt at gear drive made these beauty’s for me. Driveshaft style lakes headers for my 26 RPU. I made the plugs and routed them to my under car exhaust. Finally had the whole works ceramic coated.