Register now to get rid of these ads!

plymouth flatty cam?

Discussion in 'The Hokey Ass Message Board' started by COOP, Feb 18, 2014.

  1. COOP
    Joined: Mar 27, 2006
    Posts: 255

    COOP
    Member

    Any ideas where a person can look for a new performance camshaft for a '53 plymouth flathead? I have heard about several places that will re-grind an original, but I would rather have a new one. Thanx..(hope this post is in the right place, my other one was deleted)
     
  2. 61farnham
    Joined: Feb 23, 2013
    Posts: 12

    61farnham
    Member
    from England

  3. BillWallace
    Joined: May 6, 2011
    Posts: 132

    BillWallace
    Member

    There are several ways to do this but be fore warned it will not be cheap. You can have a round steel bar of a alloy of your choice cut or turned to make a blank to be ground. But your best bet is to contact cam grinding companys & see if they will build one for you. It would be to your advantage to just have the old cam reground unless you are building a very special race engine.
     
  4. moose
    Joined: Jan 11, 2005
    Posts: 353

    moose
    ALLIANCE MEMBER

    I've used Edgy for two cams now and he does a great job. If you are looking for a cam to send to him, I've got a few extra stock ones. PM me if interested.
     
    Register now to get rid of these ads!

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.