Which frame ? The powder coated one is from my Chevy .. Thanks it's been rough lately to work on either since I've been working 60 hrs + a week Posted using the Full Custom H.A.M.B. App!
Question - as a newbie with welding relatively speaking - how did you weld in that patch panel where you removed the port holes because, with that gap on the lower left, i would burn through...do you hold the gun at quite an angle to bridge over?
Well no new updates . Car will prob be reassembled and get listed. Need money and room in the garage so .... But who knows , I've had no luck selling it in the past .
Honestly I can't Remember haha I probably just squeezed the trigger real quick numerous times without moving too fast which allows me to build up the weld . Or I could have held it at an angle going along with the cut and done it that way. .. Hope that helps a little
Not much of an update. A lot of life going on right now. But here's one , shaved the trim holes last night. Gotta pick up some sheet metal to weld up the wiper holes
Sweet ride... I am about to get deep into my build. Its a 52 special that I am putting on a 94 Cadillac Fleetwood chassis. The wheel base is the same, the front track width is slightly wider than the buick but I should have some play room with it. Hoping to have it on the street by late April. The caddy donor was in great shape. 85K miles with LT1. Big fan of these Buicks.