J W rod garage 32 frame rails

i was looking at buying a set of these off evel bay.how is the quility of these rails .

 

Are they the Dearborn rails, just marketed by these guys?

 

they took over and are the makers of them now , so i have been told by one of their dealers

 

hot rods&horsepower,dearborn deuce ,jim weimer all the same.

 

Daryl, JWGarage, bought the dies that Dearborn Manufacturing used to stamp the Accure rails . I have three pairs and feel they are better then the ones I have used in the past...

 

thanks for the help

 

Well.....one of the guys at the JW booth at the Des Moines GoodGuys show told me they were NOT the Dearborn dies. Either way, they look nice except for the goofy radius cut on each end, but, I have never had one in a jig.

 

Thanks! Hot Rods & Horsepower is local and will be supplying my frame when the time comes.

 

I am a dealer for them.
Do you plan to pick them up?
I have more pictures on my site(see below)

 

When I bought the rails from JWG I also bought a accure chassis that they recieved in the deal with the dies, One set of rails with another set one size smaller pressed in for the boxing..Good product...

 

I bought a set of these rails from Eric. When I put them in the jig they fit so well I could tack them in place without even clamping they fit so well. American Stamping rails aren't nearly as nice.

 

Nice!

 

I've got JW rails in a chassis jig right now. Pretty damn nice fit. Minimal clamping, boxing plates fit well with minimal grinding.
Not pinched, bobbed rear for my '29 Sedan.

 

Old thread, still thinking about buying J&W rails.

Bob

 

Similar experience with multiple sets.