Headers from a 289 Cobra (wiil fit 26-27 T chassis outside frame rails)

Under car headers from an original 289 Cobra. (helped take them off)
No dents, thin spots from rust and all slip joints are good.
1-3/4 primary tubes and 3-1/4 collectors that are 3"OD at the exhaust pipe exit..
They should fit outside the frame of a 26-7 T with a 289-302 and possibly a 351W in a Model A frame.

Asking $325 plus shipping from Brookings Oregon. They are a slip joint design so they can be disassembled and fit in a smaller box to save shipping cost.
I will message additional pictures.
Movin/on
+ shipping from 97415 (Brookings Oregon) they break down so shipping shouldn't be that bad.
Mufflers not included since they are pretty badly road rashed.