I'm trying to get the glass sorted out on my 40 Merc. I ordered a windshield gasket from MACs. I cut and glued it to fit but it really wrinkles up in the corners and side. I wonder if its just not a good quality rubber or just old stock. I made masonite templates which are thinner than the glass will be so I don't know if that is the issue or what. This is a one piece gasket, it looks like Drake offers a 2 piece gasket, one for each side. Would this be a better way to go? Next question is the stainless trim around the windshield. Are most people welding this up or capping them at the seam where the chop is? Same question for the center stainless divider. I was thinking I would cut it and reform the end by hand. Thanks for the help!