Register now to get rid of these ads!

Technical 47 ford split wishbone plate question

Discussion in 'The Hokey Ass Message Board' started by mr. h, Mar 25, 2017.

  1. I got the posies split wishbone kit along with the whole drop axle set up. I am running stock transmission right now. So the instructions say to measure back from the trans cross member rivet. See pic. Well I don't have those rivets. I only have bolts where the body mount arm attaches. So where do I mount the plate? [​IMG]


    Sent from my iPhone using The H.A.M.B. mobile app
     
  2. AVater
    Joined: Dec 9, 2008
    Posts: 2,598

    AVater
    ALLIANCE MEMBER
    1. Connecticut HAMB'ers

    Mr. h

    You can call them there. I just did the other day with some questions I had. Very helpful folks.
     
    lothiandon1940 likes this.
  3. rusty rocket
    Joined: Oct 30, 2011
    Posts: 4,237

    rusty rocket
    Member

    I would call them also. I used there kit in the late 80s. My car was an early 47 and I later found out there were a few changes from 46 to 47.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.