The Jalopy Journal
maybe he doesn't like foreigners
Anybody out there running synthetic oil in their flathead v8 motors? I'm building engine for my car and haven't decided what oil to run. If not...
what oil should be used in these? :confused: rob
yes, it is John Kovar from Ohio. My question is" has anyone used one of these"?
EZ Steer has complete steering box including steering shaft for traditional steer 32-34 ford. It has 18to1 ratio, and can be bought with switch...
I'm building a 34 tudor ford hot rod. Is there any one that can rebuild and improve steering box. Don't want to cut steering shaft or use f1 box....
will 1933 ford sedan dash fit in 1934 ford sedan with no mods except for guages?
that is what I am doing also and looking for the 41a-6023 adaptors. where did you find them? thanks, rob drew:)
does any body make motor mts to put 59a block in 34 ford. sounds easy but crossmember pads are somewhat narrower than mts on water pumps. Front of...
trying to remove spring perches and radius rods from 1934 ford axle. so far heat and big hammer have not budged anything. spring and mech. brake...
thanks fellas. I think I got it.
hate to seem dumb but you are saying 2 turns on axle and 1 turn on pinion=approx 4:1 (if you are keeping 1 axle from turning)
how can you determine rear ratio without dismantling rear end. i'm getting aprox 2:1 by turning axle one full turn. this doesnt even make sense....
building 48 stroker flattie. who has run speedway's high volume pump. Is it as good as melling, worse,better or what. also where is it made. can't...
want to keep frame as original as possible. 59a block, t5 trans, 35 rearend. Also want to run uncut bones on front, and want to run 35 ford...
why can't i ask a question in tech archive
pump it full of grease, then proceed with the pull handle.
crank will be stroked to 4.250 ,journals will be smaller than later rods, plus bearings are full floating, can't spin a bearing because they are...
I need a set of rods for 221'' V8 ford. I believe they have 21a on them. they have full floating bearings and are good for stroker merc crank....
Thanks for the info. Got in touch with elgin.
ain't no such thing as a wimfield cam for flattie or a windfield for that matter.
lifters look good but putting different cam in motor. is there any good way to resurface or renew or prepare surface for different cam. 59ab 276"...
I have a Winfield SU camshaft for flathead V8. Wondering if anyone has specs on this cam. want to run it in my 276 flattie.By the way , the...
what was the last year for lever style shocks for ford and will they fit 34 ford
will these gears fit in 37-39 trans case and are the ratios better. car is 34 ford, motor is 276 flattie 59 block
Where was the shifter and could that be modified
has anyone put a super t10 (fine spline) trans with 48 flattie 276 ci . I have offy adapter, alum flywheel, etc. trans came out of 1976 trans am....
if your wheels are sportster or lowrider wheel made after 1982 they will have bearings for 3/4 axle and will be set for dual disk. you can either...
it seems that a lot of ford rods have the 39 ford trans even if the engine was (sic) other than a flattie. how can there be that many 39...
live in charleston sc. looking for someone close by that can drop 1934 ford axle 4 inches
Separate names with a comma.