The Jalopy Journal
SOLD
bttt
1937
SOLD SOLD SOLD Fully polished 15" x 4.5". 5 on 4.5 bolt pattern. Only have one. Paypal or Postal Money order. PM for more details. $200 shipping...
Add one to the list. I found this one for a Signal Stat 700.
Anyone know if the spindles on a 1941-1946 Chevrolet 1/2 ton pickup truck are the same as 1947 - 1954? I'm looking at a disk brake kit from...
So I sent him a Cease and Desist Notice and he changed up his website from selling my plans to linking his page to mine so he's no longer selling....
Go Daddy says the registered owner of his website "ratrodframe.com" is: Wolff, Joe [email protected] 22519 34th Ave Ct E Spanaway, Washington...
Thanks for all the help guys! I now have his name, address, phone, and email all linked to his website. This dousche has pictures of my frame in...
^^^That worked! Right down to his phone munber! Thank you!!
I posted a comment on his website just to let him know I know. All of the sudden he is "down for maintenance".
I submitted the copyright myself. I have the certificate to back it. The only problem is, there is no contact info on his website. Just a paypal...
In 2007 I designed a chassis for a slightly OT car I built. I made CAD plans and copyrighted them. I sell a good number of them on the auction...
I could see using this on simple roadster doors as well!
A few more pics:
Here's mine: How to build a TRUNK or RUMBLE LID from scratch http://www.jalopyjournal.com/forum/showthread.php?t=799235
Locate and drill an appropriate hole for your handle. The cable and cable clamps are used to link the handle to the latch. Adjust the cable and...
Once I was happy with the frame, hinges, and latch, it was time to put the skin on in. To keep things in place I added two temporary braces from...
Hinges: I used a short section of steel steering tubing and located them at an appropriate pivot point. Inside of the round tube is a section of...
Finish fitting: Finish weld the relief cuts and grind all welds flat. Once you are done with this step, check for fit against the body. The curve...
Cut the tubing for the sides of the opening allowing an extra inch to be trimmed off later (better off too long than too short). I used the same...
Next I measured the opening along all of the edges (across the top, across the bottom, and along the curve on the sides). I bought enough ¾”...
Here is an easy way to build a trunk or rumble lid for just about any car from the late 1920s to early 1930s. I dont have a tube bender,...
Separate names with a comma.