The Jalopy Journal
The Carter Weber set up from Langdon's is superb! I did have a problem at first with low power as mentioned above, but Tom Langdon discovered my...
I think Tom still has tons of those Carter-Weber 2bbl carbs, sells 'em in sets of two for $180. I put a set on the 235 in my Panel and didn't...
Bruce, The Langdon HEI is about the single best thing I did to my 235. Easy install, never have to fuss with points again, you won't regret it....
I have the Langdon Carter/Weber setup on my 235 with Offy intake, Fenton headers and Langdon's HEI, to replace my badly leaking (but good...
Just put a set of Langdon's Carter/Weber 2bbl carbs on my 235. Replace my old Rochesters, which after 13 years of reliable performance were...
Funny thing is the fuel filter is the only thing I didn't replace before my long road trip, stupid auto parts store didn't know what I was talking...
Thanks for all the suggestions guys ... it was simply dirt in the rear carb. Simple old school solution for an old school problem. Pinch the...
Tank has never been pulled that I know of, so no idea of condition, but the truck has run fine for me for 23 years. That said, the recent long...
Quite a bit of liquid gas in the air filter housing of the rear carb, suspecting a stuck float maybe? Not about to take a carb apart on a Sunday...
Yeah but it's the weekend and I don't happen to have a garage to work on the truck in ... my mechanic's fair and reasonably priced.
Current tank of gas is from my local Shell station where I buy it regularly, always fresh, though this tank was Regular and not the usual High Test.
You're probably right pinky, they are 14 years old and have about 45,000 miles on 'em ... however just seems strange that it would happen so...
That's one of the things I cannot check ... so off to the mechanic she goes.
Similar sort of thing happening in Ontario, Canada. Ministry of Transport is enforcing pollution control standards on all modified vehicles. If...
Went for a run today, about 10 minutes after I'm on the highway, my 235 Chevy starts running rough in a strange way. If I give it "the gas" it...
I too have only one choke hooked up on my dual carb setup, however, I never use the choke unless it's extremely cold and the truck's been sitting...
Morning HAMB-sters, Has anyone found an LED taillight conversion to fit the Guide R-17T tail lamp? These were very common on 55 to 72 Harleys. The...
I'd like to find an LED conversion for the Guide R-17T tail light ... perhaps not common enough for Chevy Panels, but 55-72 Shovelhead and Panhead...
The shiny stainless curved side brackets for the Chevy/GMC truck applications are actually in two pieces, the upper one fitting over the lower...
Just installed a Fulton Visor on my '52 Chevy Panel. No problems with "highway" speeds, had it up to 70 mph. However, if there are extremely high...
215R85-16's are as narrow as they come. I've been running these for 20 years on the same rims you're showing, with radial tubes. Man, I'd like to...
Wheelsmiths, and Wheel Vintiques all offer 16's in various widths 6" and wider, and have their own "CHEVROLET" hubcaps to fit. Vintiques center...
I'm looking for some stock-looking 16 inch wheels for my '52 Chev Panel. Need something wider than the stock 4 1/2" rims that can run tubeless...
Found this H.A.M.B. Forum thing while digging around the internet for info on hot roddin Chevy 235's ... some way cool stuff in here! ... I'm...
Separate names with a comma.