The Jalopy Journal
Cuved or Flat? If curved glass it would be early 50's or newer.
could be used as a sunroof
They have one with a 71.5 inch same design just longer posts. A solid foundation and modifying the ramps would do it.
Something like the urethane used for windshields would be good to bond it to the metal. Or bed liner while wet.
As far as the polisher is concerned he is not a restorer. Most would not want the numbers as they are no longer stock and are customized.
49 Henway?
Summit has several kits that fit Olds, Ford and AMC 1.6 ratio from their question on them I ordered the Edelbrock 60519 cylinder heads for my...
Some running driving cars need a complete mechanical redo and add up to more that it is worth. Without the specific are too many variables.
It's a custom center the front wheels.
This would be the ticket. http://www.hothemiheads.com/main_caps/main_caps_severe.html
Would be better off with a trailer hitch receiver carrier? Would not diminish the value of the vehicle....
As long as it is sealed tight the undercoating is good. if it separates it will hold moisture and accelerate rusting. make sure you have a good...
I think the 56 is 12 volt you may want to look into converting to 12 volt.
little info on how they work from speedway. [MEDIA]
Use a die grinder with either stones or sanding cones.
Sounds like poor or no antifreeze or cheap chinese pot metal.
Did you replace ball joints and tie rod ends? Make sure all suspension parts are lubricated and not binding. With the front end on jack stands it...
Every SBC is a corvette motor.
You should see some improvement in 1/4 mile times with a headlight switch.
I try to use ethanol free in small engines. If forced to use e10 i will add 2 cycle engine oil to prevent valve issues. On my JD lawn mower it...
power windows and power steering.
Did you bypass the ballast resistor? If not you are not getting full voltage to the module.
Look like blower pistons big hemi 426 or bigger.
Similar to GMC AD truck but not Oil pressure only went to 60 chevy only to 30 psi
It will work for pinhole leaks in good metal. If you have any thin spots you will only have the thin metal with however may layers of epoxy until...
Ist it an oil lubricated compressor? If so you may have a problem with the compressor.
I soldered up a gas tank. washed out first. then filled with water leaving the repair area as the highest point. When i fist heated the spot I got...
If using air pressure fill with water and use a hand pump to control it. Do not use starting fluid unless you want to create a bomb.
https://www.autometer.com/media/2650-1244.pdf
Automotive version of a chicken nugget. jumble of parts fused together.
Separate names with a comma.