The Jalopy Journal
Made in USA, JJ DOT. 5 on 5 1/2 AND 5 on 5 bolt circle with 3" back offset to rim edge. 3 11/16" dia center hole. I purchased new in 2011 and they...
Made in USA JJ DOT is stamped on the rims. 5 on 5 1/2 or 5 on 5 bolt circle with 3" back offset to rim edge. 3 11/16" dia. center hole. Ask $300...
Made in USA JJ DOT is stamped on the rims. 5 on 5 1/2 or 5 on 5 bolt circle with 3" back offset to rim edge. 3 11/16" dia center hole. I purchased...
Just putting my toe in the water here ... I've got a couple of little things left on it. Great old original truck sitting on a Cornhusker chassis....
Thank you. I had previously sent them an inquiry but I'll give them another shout.
Rule of thumb "right is wrong". the LH threads go on the right side
I'm restoring a '53 Kurtis-Kraft 500S which uses 16 x 5 1/2 Halibrand knock off wheels. The knock off thread is integral with the hubs on the...
I'm looking for king pin bushings for the same spindle for a '53 Kurtis Indy roadster. Mine are 1" id x 1.115" od x 1 3/8" long. Any idea where I...
I'm building up a banjo axle and need to replace the seals on the rear hubs. It's built up from a variety of year's pieces so I'm not sure what...
Thanks Bruce ... why didn't I think of that? Don
I'm rebuilding a Ford banjo. The ring and pinion are nice but the bearing surface on the pinion nose is pitted and sort of funky-looking. With the...
I've got one that I took off my 500S when I restored it with a wrap around windscreen for vintage racing. Don / 713 941-1025
Lots to read in the forums about fitting Buick drums to early Ford axles and hubs but I couldn't find the info about my fit up problems. I'm...
Does anyone know a source for headers for a (331 - ports too small) 365, 390 Caddy? I've seen the flanges and lakes style but need some fairly...
Hi and thanks to all who answered with some ideas. I have been out of town and just back. So far no luck but I'm still looking. I will advise...
Who can bend a 1 3/4" dia. x .120" wl. roll bar in a 180 deg bend with a tight (maybe 5") inside bend radius? Located in Houston. Thanks for any...
Thanks for the tips. It's all about the mtg offsets so everything lines up or can be adapted to line up. The (2) backing plates that I have are...
I have some 12" Buick drums but I can't find any 12" backing plates. Does any one make repop 12" backing plates. I can make just about anything...
Separate names with a comma.