The Jalopy Journal
I have a 61 Econoline. The previous owner replaced the engine and transmission with donors from a 65 Mustang (str 6). The transmission is an...
I have a 1958 Chevy Delray with a 235. Im installing a HEI (purchased from Tom Langdon). Does anyone have a wiring diagram for wiring the...
**UPDATED** Now that I have the correct gap size, I have two new questions. I read in a thread that the wire from the starter to the coil may...
Anybody know of a good garage on the Central Coast...Calif. I need some help dialing in my triple carb set up...on a chevy 235. Runs decent now...
Ok everyone. I have a 1958 chevy delrey lowered 3". I want to put wheels from a 1987 Z28 (15X7). Does anyone have any idea what size tires to...
Does anyone know if a 4 speed munice will mount up to a 1962 Chevy 235? The rear end is a stock 1958 Delray. thanks
I've been thinking about putting air bags on my car. It's a 1958 chevy delray. I put lowered coils on it, but now it's a little too low...I...
I need some help finding somewhere to buy shocks. I have a 1958 Chevy Delray. It's been lowered with 3" drop aftermarket spring, from Classic...
Does anyone know if the steering in a 1963 Lincoln Continential can be changed. My bubby has this car which turns fine to the left, but not so...
I have a chevy 235 with fenton header and offy intake. The bottom of the intake as a heat intake system. It is set up for water intake to heat...
I have a three carb set up that I had rebuilt by Dick here on HAMB. It's an old offy with three rochester 1bbl's. Does anyone know if the...
I need a new water pump for a 1958 delray. The motor is a 1961 235. Does anyone have any idea what the part number is?? Recommendation to buy it??
I have a 1961 chevy 235. I was getting ready to rebuild the distributor new points, cap etc...normal stuff. Before I start spending the...
I'm putting a triple carb set up on my 58 delrey. intake is offy. Carbs are rochester 1bbl rebuilt by dick her on the H.a.m.b. should i use...
Can anyone recommend a paint and autobody for a friend of mine? He has a 1957 Chevy that needs paint and some bodywork. He is from Pismo Beach...
What size (lbs) radiator cap do I use for a 1958 235 with stock radiator. It has a 13 lbs right now and I was told that was wrong. Does anyone know.
I recently had the cylinder head rebuilt on my 235. Today I went for a test drive. I noticed a smell coming from the engine. It smelled like...
I was getting ready to put a carb onto my 1958 235. THe carb is a Rochester BC. Does anybody know if there suppose to be a gasket betwenn the...
I have a 235 that smokes white during inital start up. After it reaches operating temp it stops smoking. Do you think it needs a new head...
I just refurbished the engine compartment in my 58 DelRay. The engine is a stock 235 (1961). The water pump, thermstat etc are all new....
This past weekend was a blast at the Hot Rod Reunion in BAKO. I haven't been to the Famoso Raceway in over 30 years....WOW I sure did miss it....
Separate names with a comma.