The Jalopy Journal
Bump. Thanks for looking.
Pair wide fiberglass running boards for 35 master or 36 master. New never used from Superior Glassworks.
Progress pics....
I have 35 master. What pics you looking for?
Todays adventure will be adding a bolt on bottom piece.
Price? Didnt know what else to use...
Though I would share my build of a tubular cross member. Started with a electrical conduit template. [IMG] Then bought some 1" gas pipe and...
Excellent, thanks rick
For 700r/4L60, 70% inside tail shaft approx.
Any rules about how much yoke should be hanging out of the tail shaft? Mine is 1 and a 16th inch between tail shaft housing and yoke. Jim [IMG]
Dont have a lot of experience with trannys, but check for an adams apple, that should be dead give away.
As soon as I finish mine it will be too.
I just did same thing not too long ago. I have 73-74 MarkIV 9 inch, used 1999 explorer rear brakes, re-drilled axle for 5-4.75. Cost $70 vs $700...
Haha, just thought bout it today whilst heading out yet again to get some parts.
How many miles have you put on your daily driver chasing parts etc for your rod before putting one mile on the project? Trips to Home Depot for...
This is for my dads 41 Chev coupe. He likes to be hands on, doesnt like to send things out either.
Thanks
Big part of the question overlooked, Colorado based companies.
Bump
Anyone know of an affordable pot metal repair and plating shop? Preferably in Colorado?
A must watch http://www.youtube.com/watch?v=Us7VDZT-NcQ How do I embed this video into the thread? [IMG]
Thought you said there was a car in the pic...
Sigh, I own one of the bastards! For the life of me I cannot get the front end together. I might have a late 34 frame, hard to tell. Everyone has...
So before this takes a turn for the worse, let me just say I am glad there is a company out there that actually offers chevy steel! I will pm you...
Exact same surgery both rockers, must have something fantastically out of alignment....
Had to cut up my EMS rockers to fit, think they would come ready to go.
Ok, I'll add there too.
Wondering if someone near Denver, Co has a 35 Master or 36 Master/Standard I can come get inspired by and take various measurements. Jim
http://www.fordification.com/tech/rearends_ford01.htm
Using some wood-b-gone...
Separate names with a comma.