The Jalopy Journal
When you compare 19Eddy30 photo above and mine the handles do not look the same
19Eddy30 my dike is steel (UP) I tried to grind away material from the side it was thicker but then the axle hole didn’t fit The grip in the...
I have a UP body
Hi What is the problem here, the handles box said Vintique Inc. handles nr: B-702350/1-L and what I can see it should be suitable for a 5w coupe,...
Thanks, I´ve to check that out
About 10 years ago I bought a 1930 Ford with a VW distributor, now I´ve bought an A-Ford again and want to use such a distributor. Does anyone now...
Thanks for answers Sorry but I can`t find any letters or logotype that tells the manufacturer, I live in Sweden and I bought the trans complete...
Hi I`m putting a 39 trans in my deuce frame but the holes will not match, are there different type of k-member or is it just bad made trans-mount...
No,
Thanks for tip, I maybe has to look for original brake/clutch pedals
Do anyone have any good ideas how to put 39 pedals clutch and brake into an original deuce frame, the angle seem not to be ok Thanks
OK Thanks
will lower stanchions from a 1930-31 roadster fit a 1928-29 roadster Thanx
No it´s not confusing, now I know I can buy the seat, Thanks a lot
Thanx for the answer
Will a 1929 roadster rumble seat fit in a 1930 coupe ?
thanks for useful answers, I`m going do use an unsplit wishbone in my deuceframe
What kind of pitman arm do you use on your 37 Hudson steering box ? mine is gone
I used Chassie Engineerings kit, but I think the car got far to high. I`ve put 3 inch lowering blocks but that´s not enough so I concider taking...
Hi, does any of you know if I can put a 59AB with a 1939 trans in an original deuce frame ? If I can, are there any other water pumps or engine...
Now I´ve reached 5 degrees, I might will try to raise it to 7 degrees after I read your comments Thanks
Fine Thanks
What is the right caster angle, or what do you suggest ? I have split the wishbone to about 8 inches between the rod ends and they are mounted at...
Great, Thanks
Hi Do you know if Early Ford Store still are selling parts ? Thanks Mike
https://picclick.com/1935-1936-1937-1938-1939-Ford-Chassis-Frame-174738487921.html here is a link to a frame with similar mounts
They are both riveted and "welded" on the top of the crossmember and they are moving the engine mounts both rearward and narrower
Sorry, I´m not able to send a picture
Recently bought this 1937 Ford frame, but I can´t recognize the motor mounts, are they original or is it something someone mounted later on
Thank you guys, much information on this page
Separate names with a comma.