The Jalopy Journal
At curb what is the closed distance from tire to body?
the narrow middle seat from a dodge van should fit. it's about 38 in. wide
I know that this is an old thread but hope Glenn is still active here. After looking at this for a few hours I finally understood it ,I think....
I built a frame from J-channel to hold rad and then shell attaches to that. see pics at http://www.ncf.ca/~da229/pics/rad-mine1-smaller.jpg...
what about the relative lengths of the bars in a triangulated (viewed from above) setup?
what are the considerations for having the angled bars wide on axle pointing inward or narrow on axle pointing outward. One point I see is that...
Is there much or any rust back with the vinegar. I have used muriactic acid and there was always some rust back.
I not cleare why you say this. Would you not phase joint 2 with joint 1 and then joint 3 with 2?
Is that supposed to be part number for fan at speedway? I entered it and got a racing sparkplug?
mine is width 18 near bottom, 18 1/2 near centre, 17 near top height is 19 , about 3 inches in from outer edge of opening
I got the idea of the crossmember from seeing one for the engine available from Speedway and CE for that engine. Neither seemed right for my motor...
I am putting a buick v6 3.8 into a model a frame (stock C channel, boxed). I am using stock motor mounts. ( not same as SBC and not same on both...
Rad size is 21 1/2 from bottom to top of cap. 19 5/8 wide at front including flanges 18 1/2 wide at rear including flanges Upper tank is 3...
I just took it out to garage this afternoon. Not sure if I have the dimensions online somewhere. Is it for an A? Here are some pics of how I did...
Found the rates. These are for standard. It's free for express or expedited but that;'s pretty expensive shipping. $0.00 to $20.00 $ -...
If you go to www.ups.ca you can with some difficulty find the schedule of brokerage charges. It is based on value in CDN$. One thing to do is get...
I have read that not all frames have it. It would match the original engine number. For title why not use the number on the current A...
My 65 V8 one as above with core being 16 3/8 h by 17 1/4 wide . I say top tank is closer to 3 " and bottom is 2". I am using it in an A grill...
I found the date on mine on the upper firewall , driver side., athough It seems only a 9 was stamped for the year part.
The 2 wd 92 one I bought was 55 from face of drum to face of drum.
Thanks. Their price is about same as my canadian source if I have to pay UPS brokerage ripoff charges. I found the Ford tractor one here in Canada...
Just building a frame to hold the Mustang rad I was about to order for my 29. Might check out this ford unit as the rounded top corners might make...
Separate names with a comma.