The Jalopy Journal
1951 Chevy truck....has inline 6 250 with turbo 350 tranny..not in truck.all glass is there but drivers glass is broke...has newer upholstered...
i have a running 331 cadillac motor and tranny still in car..the motor runs good and the tranny shifts fine..the only problem is when you put the...
1946 Ford truck with a camero rear end..the rear end has 4:11 gears in it and it shakes the truck bad when I take off out of 1st and reverse....
i have almost finished my 46 and need door glass but the glass i have has a metal frame around it..one side is good and the other is shot..i cant...
i have a 1951 caddy 62 series 4door and was wandering if there is a side glass i can use from another car?
i need a wiper motor for a 1951 caddy 62 series and was wandering what might work the best to replace the vacuum one for electric.any help would...
i have a chevy 350 and an S10 five speed and was wandering if any of you guys know what belhousing and clutch to use. thanks
does anybody know where i can get a set of new front wheel bearings for a 1953 chevy and one more thing does the 1953 corvette use the same...
has anyone put a modern A/C on a chevy 235?
so i have made my 1953 chevy 12 volt and the fuel gauge reads full and have put a drop voltage on the gauge and still reads full.does any one any...
anybody know how to set them up,should i use straight or progressive linkage and what about the vacume for all 3 and so forth,im not sure about it...
has anyone put a 3 carb setup on a chevy 235 and if so how did you adjust them and are they progressive or not.please help i am having some some...
i am looking for a set of white wall inserts or if you like porta walls.please let me know. thanks
anybody know when the next turlock swap meet.
is there a special paint or can you use just rattle can,any thoughts.
ok so here it is,i have a 3 speed floor shifter for my 53 chevy and the bracket that it comes with does work so i found one on EVILBAY and did the...
please tell me what (bttt) stands for cause i have seen it on here and have no clue,SORRY FOR THE DUMB QUESTION!!!
anybody know how much it takes to paint a 4 door car(quarts,gallons,etc.)
does anyone have a bare metal daily driver and if so what do you use to keep it from rusting.the thing is i have a 53 chevy and its my daily...
i was wandering if any of you guys have used a hurst or other shifter to move it to the floor.please help!!!i have a 53 chevy with a 235 with the...
Separate names with a comma.