The Jalopy Journal
Thank You!!
Is ebay the best place to look for those? Sorry to ask so many questions. I obviously don't know much about them other than every body else had...
Do they fit trucks?
Do any of you know if there is a remarked difference in the Hurst Mastershift three speed shifter and the Hurst Indy?
The farmers I grew up around would have asked for at least 3 (cases)!:)
It looks like I misstated the terminal numbers. I do indeed have the wires as shown in the drawing. However, I do NOT have 12 volts switched at...
Ok, that makes sense to me. I had some bad information. Thanks!!
I am trying to convert my 66 chevy truck from external to internal regulated alternator. I have found varying resources on the wiring. I have...
I got to see the Hurst Hemi Underglass in Chandler, IN once. He crashed into the rail!
I agree with the above comment. I don't have problems finding the regular parts anywhere. My local NAPA has a250 on a stand just inside the front...
Sent a PM to you!
Going on a '66 Chevy 1/2 ton pickup. I hope for the shifter to clear the bench seat.
Damn, you guys move fast on here! I went from first page to third in about 40 minutes!!
Sounds like good advice. I don't like cheapo stuff, just didn't find anybody who could tell me the difference till I came over here!
I'm looking to convert a 66 chevy pickup over from column shift. Would it be best to buy a new one with instructions?
Can you tell me more about the dual pattern?
Quite a bit of difference in price between these two to convert my column three speed to floor. Since the folks at Summitt didn't answer my email...
Guys, Thanks for all the help. I found a SEM color that was very close at a local store. They mixed it, put it in a can and I'm ready to try it...
Glenn, I just started frequenting this board, so I don't know many. You have my deepest sympathy. While I don't know what you are going through...
Rpol, I emailed them last night but haven't heard back, I realize some businesses just don't do much email, so I may try to call them tomorrow.
Rpol, I'll giv ethem a try. Stuart, yes that does look very close....I'll check the numbers and see if they have a color chip for the Pontiac
Thanks guys, the encouragement is greatly appreciated (and needed). Seems like a guy can run into a lot of dead ends on some of these projects. :o
Pimpin, I have tried that at a couple of places...they don't seem interested. Autobody supply stores are getting like parts stores...it's hard to...
If you ignore the minor surface rust, here is the difference... the dash part is browner than it looks in the pic and it is very flat but has a...
I have been trying everywhere to match the paint on my 66 C10 dash. It has never been repainted and has been in our family since new. The paint...
I am replacing all the lamps in my dash and came across one just hanging. The lamp socket is made with a couple of clips on the side and it is...
Separate names with a comma.