The Jalopy Journal
I was able to get some measurements from Scott Drake/Holley and even at their shortest they are still about 1/2" too long. I guess I could always...
Cutting right to the chase, will 64-66 Mustang strut rods fit on a 64 Fairlane? Looking to replace the rods on a fairlane, and found some nice...
1953 Chevy 210 Sedan interior trim pieces and seats. Metal trim is in good condition, "soft" trim needs a little work to be nice, and seats need...
1953 Chevy 210 inline 6 engine and 3sp trans for sale. I was told by previous owner that it ran a while ago, but it was "stuck in gear" so it...
anyone?
well of course, but not planning on dirt track usage for this one, at least not at first. we'll see
here is another question...i notice this early T10 has a front bearing retainer that doesn't use an internal seal around the input shaft. Can I...
i am going to have to give this a read sometime, thank you!
FYI, Dorman 85860 is a perfect fit tail light socket. $4 at O'Reilly!
FYI, that 9613s rear seal fit perfectly in my 7D housing with 16 spline output!
EUREKA! through that smcars.net website, I found this link: https://www.chevytalk.org/fusionbb/showtopic.php?tid/341411/ Not quite ALL...
so according to rock auto, there are multiple size seals for the same vehicle.... 1966 corvette with 327 motor and manual trans have 27 OR 32...
yeah I did a quick search last night, and couldn't be 100% sure if they were the same or not. Will do some more looking today. Hopefully Advance...
A lot of great info, thank you so much everyone! Another question...i need to replace the tail housing output seal. What vehicle should I get...
wow, thank you for the great info! i had not learned that much in all the searching I did online previously. The trans and internals look in...
that's funny because now that I think of it, I actually did not even try googling first.... I found this, but it still doesn't really provide all...
all of them! check out the picture i posted above as an example of what I am looking for.... This was mentioned above as well...i had never...
interesting....so still the T10-1C design, but produced at a later time?
I can understand that, which is why I am not too puzzled by the mis-matching tail housing. it will do fine for me. But the prod code on the main...
Yes, I have done research and searched far and wide, and have some questions to satisfy some curiosities I have about the transmission I just...
when i had my racecar (again, re-wired the whole car from scratch), I used an ARC8000D panel: https://www.summitracing.com/parts/arc-8000d well...
i have used multiple different fuse/relay boxes/solutions on multiple different vehicles. mainly depends on personal preference I think. first,...
it may be a while before I can get to doing the measurements myself. My new house is in the process of being built, and i don't want to start...
close, but no cigar....its a 1969 Nissan Patrol. which surprised me even more since they are so rare, especially in the USA.
i have never heard of this site, thank you!!
From one of my previous projects, the attached image was available (in PDF form), and it provided most if not all the dimensions I would need to...
This definitely helps, but still is not as informative as I'd need. Thanks!
Would these manuals be vehicle specific? say, a manual specific to 1949-1954 chevy cars? I am not sure what I would begin to look for. Thanks...
that is what I'm thinking....i may have to break out the tape measure and just get started on it. Will definitely share it up if/when it is complete.
That is amazing, thank you! But it doesn't give me all I need to accurately design the frame...
Separate names with a comma.