The Jalopy Journal
i'm using the terminology in the title of the thread to refer to the vertical dimension between the rear axle's pinon centerline and the axle...
so there was a lot of good discussion about dual-disc clutches for a "tire-smoker" type launch in Rocky Phillips thread when he was putting...
ok, an esoteric subject to say the least, but i'd like some more visual input before fabricating something if anyone has anything. in those days...
I seem to remember a Car Craft or HRM article from the mid-60's detailing Zeuchel's buildup of Jimmy Nix's Nitro 392 when he switched away from...
[IMG] [IMG] [IMG] [IMG] i've been involved with this resurrection for a few weeks now and i thought i'd share the progress so far; but let me...
i would like some input on some backyard techniques anyone has used for joining mild steel or cast steel/ductile iron to grey cast iron, such as a...
i think there was a H.A.M.B.'r who built a long-rod GMC for their HA/GR a while back using the hudson rods and chrysler flat 6 bearings. did a...
typically speaking, were most filled combustion chambers in iron heads achieved by simply filling with weld or brazing in an iron "slug" such as...
i kind of stumbled on this site today. i have no connection to them nor do i even know them, but what a cool place! they have a pretty nifty...
i have an old bakelite Mallory Voltmaster Coil i want to run. are these internal resistance coils or external? what ohm resistance value is required?
the vol. 1, number 1 August 1951 issue of Hop Up has an Isky ad at the bottom of page 38 that describes.... "A special brochure prepared by...
Dual-point conversion the Dyna-Flyte way... i cleaned up my GMC Delco distributor this week, scotch-brited the rust off, masked and painted the...
i'm using a '56 passenger 235 bellhousing and fork behind my 248 gmc. the trans i'm using is a '63 Ford f100 3-speed toploader that has the 1...
ok, a lot of us seem to be at least weighing our options and perhaps considering roller cams in our collective near future due to the...
anyone have pictures of the "Paul Priest Special" track T that Rolla Vollstead ran in the Eastern Oregon Racing Association around '49-'53? the...
...for 352 v8, i have a possible use for some pistons but need this spec along with pin diameter. anyone up for this?
Separate names with a comma.