The Jalopy Journal
Bump
Just me but I'd put an Oldsmobile V8 engine in it.
Here's a LH driver's side curved panel above the door for a 28-29 Model A Coupe. Also included if a RH panel that I think comes from a 30-31 sedan...
Bob Drake repops the F1 mounts, I got mine from Summit for 80 bucks shipped if you don't care that they are reproduction. Still very good quality.
I'm trying to remove this bracket from my 29 Model A coupe but it laughs at me. Is the welt spot welded to the quarter? Not sure if there are spot...
Sorry I forget Michigan may not be the center of the universe . https://gilmorecarmuseum.org/about Check out their web site
No doute this has been discussed before but I'm gonna just stir the pot. Gilmores needs to put on a TROG type event. Do we have any around...
It's not right.
Rack steering has been around for a few years. I'm curious what that came out of? Some sort of drag car?...
Below it there is room but puts the bearing right at the mounting flange to the diff, and not enough room above it to where the tube tapers. Maybe...
So I need to shorten the torque tube on my AV8 project. I've done all the research but have one question, the torque tube/driveshaft is out of a...
If I did the math right it should take about 11 gallons, isn't that about what a stock model A tank holds? Still yes your right it won't get me...
I see no reason you can't, you can make anything fit. All depends on your fab skills. I would start at the front and fit back.
Nice, I knew folks must be doing it but I've never seen one. If I figured right it should hold just over ten gallons, enough for cruisinge around.
So I just got an implanted devise and doc said I can still weld, NO STICK but I can mig and Tig. Still waiting to hear about plasma cutter. Miller...
So I finally picked up a B17 bomber air tank I want to use for a fuel tank on my Model A coupe. Anyone else doing this? Post a picture of how you...
I like it.
Forgive me if this has been discussed before but I've searched and can't find what I want. I want to rebuild a pair of 59A water pumps and...
Picked up another 59AB yesterday and found this on it. Did a Google search and found they went out on 1962 , just thought it was cool....
That was more less what I did, I was about to use a hand held impact but using a punch to unscrew the jet did the trick.
A thank you to everyone , after heating, bad words, PB blaster, more heat, I got it moving by taping on a shoulder with a punch and she finally...
Yes I've considered that but am a little afraid that I'll run the drill off and ruin the carb .
Pictire
So I'm rebuilding another Stromberg 97 but one of the idle jets is not cooperating . The screwdriver slot is/was buggered up, I've heated and...
I have a set, works great for heating and cutting but struggle getting the right tip to braze, but that's fine I have a Tig and mig.
Could it be Canadian, french, German, or some other foreign thing?
I've reached model A front main for a reverse eye, you just have to have is a press and take your time, took me about an hour in the press. Rear...
I like it, is that Edsil or Chrysler head lights?
I give up, I picked up a Mercury 8ba engine and have trying to date it, the code stamped on the block the rear is F27Z as shown on the picture but...
Separate names with a comma.