The Jalopy Journal
To clarify my above post: The adapter shaft would only about 4 - 6" long (if that helps). If I am hijacking this thread please omit.
If not the whole shaft how about a male / female 3/4 36 spline taper x 3/4" coupler (female) stub shaft to enable a steering wheel swap? Clear??!!
Beautiful design!.... Beautiful workmanship!
I have one, Kiwi model A, mounted in a '28 CCPU that I am working on. It was installed on the chassis when I bought the project and has all the...
'28 Phone booth with a banger... Bitchin!
Excellent job! Nice build on the truck also.
I like the direction you are taking the roadster. Recently purchased a '28 CCPU and want to take a similar direction. Your build is a great...
Great car, very well thought out and logical tech. Great inspiration for my '28 closed cab pickup...THANKS!
I grew up in Colton in the 50's and 60's, cruised E street. Currently in Havasu.
I have 2 completed (as completed as they ever get!) cars sitting in the garage with a '41 Ford pickup project on the sidelines. My situation is...
My avatar is my '38 Tudor, 8BA, T-5, open drive '40 banjo sitting in front of the London Bridge. I've had it for 20+years.
Getting ready to start on "the wife's" '41 and your build is both inspirational and a great reference. Subscribed!
My '38 is my avatar!
M21 with Hurst behind a dual quad 454 in my '58 Chevy 1/2 ton. A real hand full.
In 1964 I traded a guy 2 shotguns and he gave me $10 and a '59 Morris 1000 convertible. My dad and I restored it including rebuilding the engine....
I'm a little prejudiced (my '38 in avatar), I like em!!
Running a '49 8BA with a S-10 T-5, open drive line banjo, 3.25 gears, transverse spring, split '36 radius rods and a torque arm in 1938 Tudor...
Thanks for the replies. Trying to get a hold of GMC Bubba... no luck yet.
I've been having fun with my Sun MD-1 distributor machine working on points type distributors and would like to adapt the machine to work with HEI...
I recently acquired a NOS C8CM (passenger side) and am looking for its sister (driver side). Not very rare I know, but I'm just starting a...
Is there any reason it can't be rejuvenated?
Just bought a NOS C8CM-B right side head from Canada and will polish out for wall art if I can't find the mate. In my limited research I...
Subscribed. I have an early 50's Distributor Tester model MD-1. Have updated the electronics and added a power source instead of using a...
Lake Havasu City, AZ. Great weather, no DMV bullshit. Plus the lake to hot rod on in the summer when it's too hot for the street hot rod. Small...
Thank you all for relating your experiences, good information. Larry
Something that I forgot to list and may factor in is, due to linkage / firewall clearance, I am using the front carb as the primary. Don, thanks...
Has anyone using an Offenhauser 360* low rise dual quad intake with Edelbrock 1404, 500 cfm carbs and progressive linkage experienced lean fuel...
I installed a T-5 in a '38 Tudor 4 years ago using Cornhuskers components. Had to split the wishbones (I used a Pete & Jake's part). Used a T-5...
Got it together. Found out that even though you may have a case with the same casting number such as C7AW-E, The internal configuration can be...
Has anyone else ran into problems installing a Trac Loc carrier in a standard Ford diff case? Bought a new unit from Summit and 3.50 gears and it...
Separate names with a comma.