The Jalopy Journal
I personally don't get it. People paying top dollar value for project cars? This kind of reminds me of when Barrett/Jackson started showing their...
I don't have a manual, but I know those are great machines. I'd say its about early 90s vintage and I believe those were made by Esab for L-tec....
I recommend a Comp cam High Energy 268. It is like a more modern grind of the 350hp 327 cam.
Care to share those prints???
I have an old Dialarc also and weld aluminum all the time. Like said 100% argon for gas. AC and HF on continuous. For 1/8" aluminum set the...
Open the top ring end gap .010 more then the spec sheet says. Those pistons are noted for the top rings expanding and touching and breaking the...
Ditto what he said. The ring end gaps are critical on those pistons. I always set them on the loose side.
I always run AC R44 in the Camel hump heads. Even with flat top pistons you have to watch the extended tip plugs. If the block has been decked and...
Thanks Deuces! a couple taps and it came right out!
Hello, I'm rebuild an older holley 1850 4 bl that I've had on a shelf in my garage for about 10 years. It was going great until I removed the...
I've built circle track motors for 20 years and many with cams very similar to that one. I'll tell you that you will love the idle, but with 8-1...
I have a Dialarc 250 ac/dc hf with water cooled 300amp torch. It will weld 1/4" aluminum with no sweat. This machine actually puts out about...
Hello, I did a 283 into an S10 back in 1995. I used a t5 with bellhousing, clutch, and hydraulics out of a late eightys z28. Everything bolted...
Separate names with a comma.