The Jalopy Journal
For those who make there own repair panels mostly floors, what are you's using for material to copy? I've used cardboard boxes before but to me...
So on my lil 50' Crosley i'm building a disk brake setup where's the best place to place the caliper traditional front of rotor at 9 o'clock or...
My lil Crosley do to brake upgraded/modifications i have to make new steering arm for the spindle. The original had a threaded tapered end and i...
So i finally got a reverse swing arm assy for my 50 Crosley project and i'm not sure what size master cyl i should be running. The set up is...
So i reversed a Corvair steering box now the only one i could find was the long shaft one. Everything is done except the shaft need's to be...
So i seen this diagram on here and wired up my rear lights. I'm running just a single light (1157 bulb) on each side in the rear (want to keep it...
So i've ran across this before on some of the old 50's 60's vehicles I've owned. The undercoating? It basically looks like hardened tar & asphalt...
On my 50 Crosley i just finished up the floor pans/tunnel and part firewall. idk if i just wanna go seam sealer then paint or a bed liner or? Deff...
So i'm starting to put my car back together and i want to set the pinion angle. I know the vehicle is supposed to be complete and sitting level...
My 50 Crosley project i'm building installed a set speedway motors leaf springs/shackles/hangers and they came with the black nylon bushings. Now...
I'm hoping i got this right? (measuring with drums and from wheel mating surface) Original rear end is 41.5" Wide New rear is...
Ok so my car originally had a oil bath air cleaner. As i'm redoing the car now i'm trying to think of the best air filter. I'm not concerned about...
Hey everyone i got a small engine from my 50 Crosley and from the factory it came with pal nuts on the connecting rods and dist nut. Now that it...
I got a sbc i'm building and im to the point of lifters my block is a vortec so it has factory roller cam/lifters. I got a new comp thumper cam...
Separate names with a comma.