The Jalopy Journal
[ATTACH]
Well I swapped / installed an other brake kit And that kit fixed the camber But not the brakes issues I post a picture of the kit I think for...
Well believe it or not The issue was the brake booster After swapping an other and different disc brake kit and i was still having the same...
I checked it out . Piston fully retracted . I only have space at the outside pads. Not the inner one . The space between pads and rotor is .097...
Sorry I will check the amount of slide of the caliper (pads remove) this weekend
This picture come from my post from the 20 december . 3 pictures I placed a clamp on caliper to see how much the piston will go back. Then yes...
I really start consedering that... I will have to get new coil too...since the actual one are cut...gonna too low with those spindle
Both side are burnished . I had different set of a caliper on it I really doubt the calipers are the issue And everything , braket , rotor...
The spacer is there. Zoom in the picture. At the spindle, the steering arm bolts in with 2 bolts At the first bolts the caliper braket become a...
I cant bolt the braket without the spacer...or if i do it will bend the braket
Correct
About the25 seconds about stock or dropped spindles and left right brackets. Do you think that should also apply for lowered coil spring only as...
So far last test i was able to do today With the clampon it. It is as far as it can go . it didnt move much
thanks for your good eyes . i dont reply enough to your post sorry but believe me i read them . i think you right the problem must around that for...
i even saw this video on you tube look like the same kit than mine [MEDIA]
I have it the same way...yes a bolt is longer one mine...but i know there kit that require sometime to cut them out .
just before intalling the disc brake kit i swap the old coil spring for new one the old one were cut and sag badly i cut the new coil little by...
big thanks for your detailed and very informative reply .hoppefully i will have time this weekend and will look at these blots/pin
yes................
i bled them out of there brackets bleeder upright
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]...
I will get good picture soon as i can.
I hear what you said here and believe me its a learned lesson The kit that i got didnt came with spindle. I still have the original spindle
When i did a pressur test i had to remove the caliper from there braket and I put a block bettwen the pads. Block was smaller/thiner than the...
My problen with the stepbore is the booster...it doesnt fit , Not enough space with the engine. Unless if there is a small booster for stepbore ?
Yeah i was looking at one of those..but they kind pricey...do they work with the wheel on rotor?
Metric caliper The one that can be find in the 80's gm cars . pre 79 to be exact ( no low drag caliper )
Its what i did...
well i must have the oldest tread going on in here....at least im good at that ahahah wwell well well i went with other pads i did get from the...
what are your suggestion ? what should i do? or test?
Separate names with a comma.