The Jalopy Journal
I have a set of fenders and a tranny for it. I know nothing about the condition of the tranny though.
I picked up an s-10 chassis today. Its been bagged and c- notched. My intention for this is chassis is to put my k-2 binder on it. can you guys...
the belts from the old belt driven drills or other shop tools. worked for me
I want to thank every body that responded to this post. From reading these and talking to some more friends in town, the same thing keeps coming...
you are right about the type of cars. the guys I was talking with were in the 40 to 50 range, with one exception being around 70 +. as for the...
I was BSing with some guys today at a local car show. I asked them why we did'nt have a local car club. the town had one 10 years ago that went by...
if you guys can send me a picture of the caps you're looking for, I might have them. just bought a shed full of hub caps. approx 500 of them GOAT...
Past lane, that is it. I looked but never found any thing on it. thanks. KIWI. that bench is the same as the center section on mine, the side...
picked up this cabinet about a year ago. has the alimite logo on both side doors and one in the middle at the top. it came out of an old service...
Dirt, I think that you misspelled you're name. It should be DICK Get over it. take a pill, take a drink, take a deep breath. but JESUS CHRIST,...
I have not had the chance to meet Steve yet. I have seen the last two of his projects, that are still in the build process. both are 1 of 1 models...
30 x40 shop, walls, ceiling, doors all insullated. use an old fuel oil furnace to maintain about 40 degrees. hence nothing freezeing. main source...
after reading these post, I'm starting to think I should just rebuid one or the other. a 327 or the 283. and leave well enogh alone. I allso have...
see what happens when I listen to some body. ass backwards that could hurt. ok, good thing I didnt buy the 327 crank I was looking at. 327 block,...
ok, here we go. I am going to build a sbc 302. I know that I need a small journal 327 crank in a 283 block. what I am not sure of is what rods do...
The name of the yard is Castle's auto parts, the head honcho there is Jay. His brother is also there, Chris. I was there this morning, looking for...
Thanks for the input from everybody. I have been trying to call him this evening, no answer yet. To let him know what I have done to him. I think...
I have a question for all of the guys that are still running or trying to run origanal equipment on there rods. Do you guys have a source for...
I am thinking about building a frame for a project binder truck. what wall thickness do you guys recomend for this. low to the ground and possible...
well, in central Indiana, scrap has droped off to nothing. talked to a guy that works for a local salvage yard yesterday. he told me that the yard...
this one is not fuel injected. in fact it has a 2bbl holley on it. that was my first clue. it also had black valve covers on it. full of crap,...
did gm make a 375 hp 327. a guy told me that he has one for sale. I looked at it today, took the #s off of the block. ( wrong ones) he also told...
about 50$ a ton for car bodys in central indiana
I am heading down there tomorrow evening. bringing the family, an r.v, and the 57. any suggestions on a good place to camp. I was planning on the...
where do I find a book that tells what the casting numbers stand for. year, engine size, vehicle that it was used in. you guys know what I'm...
I think you can find the patch panels you,re looking for at Dennis Carpenter. they can be found on-line. the front fender rot on the front top is...
Separate names with a comma.