The Jalopy Journal
[ATTACH]
this really sucks ,,,I am really good freinds with tom,,,,we talked about algon stuff alot,,,, man this sucks
Andy brizio remade the cragar blower drive with no cragar logo in the late 60s early 70s with the t bucket craze ,,,,I have a sbc 471 intake that...
I am sure the guy who did it is full of excuse ....and is the greatest welder and fabricator : :
has anyone ran 4 exhaust pipes the full length ,,instead of merging them together??????
swap meet
anybody remember national speed center in san jose,,, on san carlos st:cool:
I used to lay in bed late at night ,,when I was 12 ,,and worry that gas would be fased out that was 1982 ,,I needed it to run my gokart..and it...
whats the deal:D
you called:D
x2 ...will they make 2x or 3x again
jasco aircraft paint remover ,,,only on the glass
they were sand casted.... and I think they were called slots or kindney beans
the early broncos had the narrowest rear end ,,,and if those backing plates are 10 in drum by 2.5 wide.. they are the same backing plates used on...
maybe 3500.00 for the whole set up
HELL NO :mad::mad:
all of his early parts he made are bitchin ;);)
great photos:):):)
paint remover works... and dose not hurt the magnesium....;);)
pic
a hub with 6 pins with a treaded snout of 2.5 or 2 5/8 ...pressure plate for the wheel or (dose it have a built in pressure plate) and a knock off
making and holding that drum beat on a drum set is badass ,,,alex vanhallen
[IMG]
a real shelby steering wheel for a 65 mustang with the horn button that says CS for 40.00$ at the berryessa flea market in san jose ,,in 1992
this is what I know ,,,the owner of paw sent me this email also about the finned aluminum hemi oil pan,,,,,,,,,,,,(Hello jeremy. We are currently...
thanks for pics
thanks for the pics
pics
heat will help,, but I also did it buy bolting a large slide hammer on the bearing end of the steel tube and bolting the magnesium bell to...
Separate names with a comma.