The Jalopy Journal
Sold
I'm selling my 33 coupe. Zero rust and lots of metal work. Floor is also complete. 30k obo
I should probably get those pieces??
Oh ok. I didn't have those pieces and I was wondering how the trunk latches. I welded a bracket and loop behind the below the deck panel to catch...
Is it a set? Both are needed?
What do these panels do, what purpose do they serve?? Are they necessary? they are for my 33 5 window.
im selling my 1930 1930 ford model A. body is all steel with no rust. custom made 32 chassis from californa roadster company out of bakersfield,...
I wondered that. I only have one wire going to the sending unit that’s threaded into the block. Maybe I need a separate ground from the gauge to...
Soooo dodge that bullet!!! Drove to and back from work today. My gauge was reading 55-60psi @50mph (no tach) and 35-40psi at idle. My gauge would...
I’m running a electric fuel pump. Not smell of gas in the oil.
I just connected the mechanical gauges. At idle the gauge goes to 55-60psi and goes up with revs. This was also the case with the original...
Thanks guys. I highly doubt it’s the bearings. Aside from zero knock noise at any rpm, how can the pressure be high then after some miles drop low...
I have been driving my model A with a 54 331 hemi since 2019 on average 6 months out of the year. Last year I notice my oil pressure gauge reads...
It would be nice if you repop those.
Yes that’s exactly what I plan to do. Thank you for the visual. I figured the recess in the subrail was for the pillar bracket. My pillar is...
The last photo shows where the bottom of the b pillar was cut off
[ATTACH] [ATTACH]
I have new flooring and subrails. No pre drilled holes. I only have the subrails on the frame, mocked and held by vise grips.
What’s TTT mean?
I planned on doing the floor first but the existing bolt hole are for a truck cab. I thought of using westcotts diagram dimensions but the bolt...
I agree. But I have nothing to attach the body too. I’m missing the pillar tab and the cowl inner braces. If I had those I’d be able to drop the...
I don’t have the floor on only new, no holes subrails. My frame is a truck 1933 frame, so no pre drilled holes for the B pillar attachment. And my...
These are the holes you mentioned? Also note location of radiator, that’s correct?
[ATTACH]
Awsome thank you.
It’s not on westcotts dimensions drawing. I even called them. My frame doesn’t have those b pillar hole because it’s a truck frame, still a 1933...
Does any one have the measurement for the hole that is on top of the frame that the b pillar attaches to? From center of crossmember to center of...
I have a aftermarket aluminum radiator. How does the hood and grill attach to the radiator? And how does the hood attach to the cowl?
So I won’t use that hole since I’m going fenderless? I will use the hood and inner fenders.
Separate names with a comma.