The Jalopy Journal
Hi guys I want to make valve lifter indexer to be available to print on 3d printer but i need the bolt pattern including all hole angle from the...
Hi guys. Bough 8CM merc Flathead but the guy who sold it to me said that he lost oil pan for this motor. Will EAC or 8BA pan work? Unless any...
Hi guys. I would like to make new distributor based on what Bubba does. I'm not trying to be competition in any kind, it's just a matter that I...
Guys is that what should happened? [MEDIA] Thanks for any advice. Sent from my ALE-L21 using H.A.M.B. mobile app
Hi guys I hope someone can help with this matter 1950 0BA flathead, rebuild, rebuild carbs 3 deuce intake. Cannot get it to start..... Can...
Hi guys. Does any one know the right sequence (valve lift/cylinder) for adjusting valve lash? I don't want to keep the crank spinning to see which...
Guys i`m in need of replacement bags/sleeves for my shocks. any one here might have anything available? Ridetech sales/customer support seams not...
Guys. Normally i will measure the trunk area in my car but i dont haee access to my car right now. I just need.desperatly to ask you if you can...
Can any one tell me how much they worth?? i might have a chance to buy them at some point. i know they rare. thanks for any info
Hello guys. I need your help right now. It was 3 years ago when i tried to repair my frame. After i replaced the side rails the frame end-up...
Hi guys Does any one here have 62 continental with air ride spring on the back? if yes could you post some pictures showing your mod? the reason...
guys would 4 door 66 galaxie rear lower 1/4 section fit 66 2 door fastback??
Hi guys, Does any one know where about in houston I can find a place with old cars? I need complete rear for my 66 galaxie fasrltback, i mean...
Separate names with a comma.