The Jalopy Journal
The oil temperature is a primary concern. It needs to get above 212 (sea level) to get the water out. Oil usually runs about 30F hotter than the...
N2 is the code for 4 note horns
Used snipper to make a pic of the chart then posted the pic.
Comparison of high gear RPM. [IMG] [IMG]
Looking at your avatar I guessed on a combo 3800 pounds, 290 HP Here are 3, 0 to 1/2 mile, graphs with 3.08, 5.38 and 4.56 gears. [IMG] [IMG] [IMG]
Cathode towards alternator.
Conversion regulator; [IMG]
I saw my neighbor working on his 65 352. He was throwing the spark plugs into a vacant lot, when questioning him he showed me the Fire Injector...
To make it easy, you burn 1.5 times the fuel at 3500 for the same HP as you would at 2000. So if you had 12 at 3500 you would get about 18 at...
For a given speed it will take X horsepower to move the car at say 70 MPH. The slower you turn the engine the more torque it takes to make that...
You will get a lot of different opinions and experience. Here is what MBM Tech Support recommends.
Here you go.....
1965 Mustang Coupe 289
These are still around; [IMG]
Breaker Points can only handle 4-5 amps without premature wear. So they used a total of about 1.5 ohms coi resistance (12 Volt) and a "ballast...
I found info that says the IC12 coil is 2.1 ohms and is used on 6 or 12 volt. It will probably work without a resistor. If it runs hot MSD has a...
That is a 6V coil I believe. I am sure the MSD can handle the current but I would be concerned about the coil running hot, maybe Bubba has run...
The coil is 1.5 ohms so will flow 8 - 9 amps when saturated. I would use a 1.2 - 1.5 ohm ballast resistor. The MSD can handle the current but the...
The belt is bottomed out because the pulley is too wide. The shiny part is where the belt is slipping. Posted using the Full Custom H.A.M.B. App!
That's my point, there Are so many variables once the tires are loaded in corners, body roll, bump steer, slip angle etc that thinking you have it...
I know Chevys in the 30's both Trucks and Passenger cars were set 23 degrees on the inside when the outside wheel was at 20 degrees. 47 HD...
I forgot to say the yellow (25), Green (50), blue (75) and red 100 = power levels....
<iframe width="560" height="315" src="//www.youtube.com/embed/VHH36crKwkQ" frameborder="0" allowfullscreen></iframe>
Here is the BSFC map of a 1.9L Saturn. The challenge is to be in the sweet spot. [IMG]
Reynolds number!
From another view; The Starburst Oil Myth -- The latest myth promoted by the antique and collector car press says that new Starburst/ API SM...
Subsonic aero is well understood. F1 cars have terrible Cd. They are all about negative lift. At subsonic speeds we are talking some form of...
[IMG]
Measure your pulley and compare to this one; [IMG] Or pick from here; http://store.alternatorparts.com/pulley.aspx...
There are so many types its impossible to say. If it's a true duty cycle type it should work.
Separate names with a comma.