The Jalopy Journal
IMHO, they blew it. Rodder’s Journal wanna be. I personally never liked the pro stock era. Those of you that do will love this issue. Maybe...
Brookville Roadster has them
Brookville, after building it, I realized a Pete & Jakes frame would have better. If was ever did again
You did a fantastic job on that coupe, you were nice enough to give me the color of it, thank you [ATTACH] [ATTACH]
Gibbs, it works and I had no issues with paint afterwards
My vote is to weld. It worked for my A coupe
It’s all good ! Changed the oil and filter, ran it for a while, changed the oil again and it was clean. Probably as previously stated, just some...
Are you propositioning me ??:eek::eek::rolleyes::D
Thanks, Don :)
Fun thread ! My 31.[ATTACH] [ATTACH] [ATTACH]
Plenty of better suppliers out there.
Maybe you need an intermediate support on the lower shaft to stabilize it. Hard to do with just two joints. Borgeson sells them
[ATTACH]
If you can find an original you’re better off fit wise. Try the HAMB classified
And thanks to you for pointing out the problem
I’m working on it ! Went up to @oj’s place, Clark County Speed and we whipped up this solution to @lostone concerns. OJ welded a 3/8x24 stud into...
I have a 32 Brookville chassis pinched for Model A. Not a bad choice although if I was to do it again I’d use a Pete & Jakes 32 frame. But as...
First I heard of it !! Damn !!
It’s almost a roller !! :D
The black brackets hold the assembly on the body, one is a simple u shape, the other is like the toe of a shoe that holds the end. These are...
@wugs, the pins are in the unthreaded hole. The bracket pushes it out by 1/8th inch. The bolt hole on the bracket is counter sunk so the pin is...
Thanks lostone, I’ll try that
Welcome from Virginia :)
Update ! Pulled the calipers, made sure they are fixing properly. This pic is the back side of the caliper mounting bracket. You can see it’s...
@nochop, that’s not my rusty front end, it’s @lostone’s front end. Drawing board ? If in fact in it is the bracket, there really is no where else...
Thanks@nochop, I think the pads got out of position when I was test fitting the fenders over and over again. Gonna pull them tomorrow cause the...
No offense taken, no worries. Appreciate the info. The caliper is a GM P- metric. I never imagined the bolt head itself would move as the pads...
Thanks for your reply,@lostone. Let me ask you this, do you think an 1/8” washer on the caliper mounting bolt would have the same effect as you...
Couple of more[ATTACH][ATTACH][ATTACH]
Sure, that is the weakest spot and so I used a piece of 5” X 1/4” pipe cut into quarter sections with a straight piece to bolt into the caliper...
Separate names with a comma.