The Jalopy Journal
Nice. That's the way the aftermarket one from the late 50s basically worked. I think the aftermarket ones had a bracket attached to the trans for...
Not quite, I'll explain it with transmission shaft rotation to make it easier to explain. The horizontal shaft is the selector which determines...
Thanks for being so patient. I finally got prices to make all of the parts and supply the hardware to make a complete kit. This was not as easy...
The guys over at P15-D24 got my interest up and I went over and joined their forum. They are very interested in some of these shifters. I am still...
Today I took the drawings to one of the shops I use so I should have a price figured out in a week or to.
Wow! You want me to build some of these. Rube would be proud. I made hand drawings of all the parts. I'm out of town for a few days. When I get...
Welcome from the wet side of Wrustingtin. I just joined on the 1st. I've got a '33 Chevy Master 2-door sedan.
I thought I would show a picture of my 33 and the engine I will be putting in it. Hopefully I will get started on it sometime this summer.
The trick is to make billet parts that don't look billet!
I got over to take a couple shots of my friends 33 Ply. One shows the front of the frame with the kick out and the spring hanger. The other shows...
I built this floor shifter for a 3 spd Chrysler selector trans. Just wondering if anybody else has built their own 3 or 4 speed floor shifters for...
Here are a couple shots of my brothers 51 Ply. It has a 55 Chevy radiator. The Cool-View and water outlet is a direct bolt on. No mods required.
A friend of mine is building a 33 Ply couple with a 241. The very front of the engine is over the axle. I am helping him on it. It came from the...
You may be able to get a NOS one from http://www.bradsnosparts.com or http://www.mmpar.com They both have a lot of NOS parts. I think some of...
I have had some success with using JB weld on stuff like that. The one thing that will make a big difference is make sure the part is clean and...
Very nice. Did you have to modify the water neck so the thermostat would register in it?
I have not used the Stamped steel gaskets. I only use composite or o-rings depending on the application. The stamped steel should be ok if your...
Well this is my first thread. Hope you enjoy. I would like to share some of the information I found out about Mopar thermostat housings and...
Yes and the fact that the stud came out is a good thing. Studs can be a royal pain to remove. You will have to put sealer on the threads when...
"Cool on that cool view" Thanks, Glad you like it. Have fun with that 59. They are hard to find without being a rust bucket.
SAM123, I Just joined today and saw "SAM123" and thought I know that from somewhere. Then when I opened the post and saw the plate OH yeh! I have...
Well I have been checking out stuff here for years and thought I should finally join. I would like to give back a little knowledge from time to...
Separate names with a comma.