The Jalopy Journal
Wow, lots of imputs and cool ideas. Thanks you all. If you have more to suggest, do not hesitate Thanks again
Hello, Looking for some traditional dashboard knobs to use on my modelA. Dont want to use billet or aluminium one's. i can't find what suits me...
I have everything in place on a model A frame, i already run an electric fan. Everything will be transfered on the pinched chassis but before...
It is exactly what i'm looking for, i'll really appreciate your measurements. Centre radiator mounting holes to centre of biscuits mounts if...
Second time...first Time was to put my combo on an original model A boxed frame (car is fendered). I enjoyed the car for a few years the way i...
Will try this, thanks!
350 sbc with th350 trans, no fenders Chassis is a repro 32 pinched frame from Socal. Firewall is an original 1930.
Thanks you for the link, It helps but i have the biscuits style motor mounts (flat head style) not the one used on the P&J tech sheets. Not sure...
Hi everyone ! I have a 32 pinched frame for a model A. I want to install my sbc chevy engine and would like to have some measurements to confirm...
You're right Chris it should depend on the angle of the carburetor mounting wich i think should be at level. For what i know and what i've seen...
Well i know the basic rules of pinion angle...just wanted to know what is the angle i'm expected to find at the tailshaft housing of a th350...
Thanks for the clear schema.
Thank you gimpyshotrods ! I can read 5° on my model A SBC setup but was not sure if it is a usual set up angle. I'm working on another chassis so...
Hello everyone, Just need a measurement to confirm what would be my set-up on my rear end. When you place a 350 sbc at level (O degree at the...
Ok. Thanks benniesrad
Very nice job! I'm going the same way...30 coupe on a 32 pinched frame. What did you do on your frame for the body mounts ?
Hello, I'm looking for a 12v wiper motor for a 1930 model A coupe that allows to open the windshield and fits to the original place with no mods....
Will do, thanks
Thanks for all the answers hamber's!! I am not looking for an original shell but a good quality repro shell. because they are pricey i would...
I'm looking for a new shell, not an original one but a good quality shell.
Hello HAMB members, Any advice on where to buy a good quality new original 1930 model A chrome radiator shell ? JF
Thank you all for the info's! Will help.
Hello everybody! i'm keeping to built my model A hot-rod and another question is on my mind at this time. Since i would like to keep the interior...
Hi! Just wanted to say thank you to all of you guys that helped me to set up correctly my engine. Engine and trans are now on my frame and...
I hope so Tman!
Will bolt the mounts on the engine before tack welding for sure! Good explanation norms30a, thanks. With all this, i have lot of ingrédients to...
Will have a look on this thread, thanks bgbdlinc
hi scrap metal and go twichy! Thanks for the imputs!
Go twichy, Is it a stock A frame with radiator in the stock position ?
Separate names with a comma.