The Jalopy Journal
11 year later any problems with this method..spring breakage? or ay other..did you just use clamps to compress the spring pack..did you leave any...
[IMG] [IMG] work on it this summer slowed down alittle...driving it allot, quite a few cruise in and 4-5 local shows, fun project
3" chop would look good....Pontiac's rule
thanks guys saved allot of head scratching
one last question is the seal not shown under the the bearing retainer...so in order bearing retainer, seal, bearing, then retainer ring
I see how the bearing retainer keeps the bearing from coming out but what keeps the axle from coming out....
this one needs a slide hammer.....I still don't see what is suppose to hold the axle in. Is the wheel bearing cap what holds the axle in.....and...
Ok....I have the what I calling the cover over the wheel bearing unbolted do I just slide hammer the axles out or is there something else
I have a early pre 57, I think, posi rear end (no drain plug).. No cover plate on rear. To replace the wheel bearing do you take off pinion nut...
[IMG] [IMG] This is what she looks like now...working on interior now and having allot of fun driving it....lots of thumbs up
how about old Pontiac's [IMG]
3.8l ford v6, c5 auto got it registered 3 weeks ago...just finished duel exhaust, working on interior now, finally get to drive it around.....
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Progress pictures drive train in ,brakes and wiring. lowered all around. put keyless door...
I have 2 lenses 2 outside rings 1 inside ring and if I can find it1 reflector
I have a 37 Pontiac coupe with stock headlight buckets with trim rings but no guts. I want to convert to sealed beam headlights does anyone make a...
got axle lowered moved forward and mated to mustang driveshaft
Good catch on your part, but rear end has to move forward at least 3 inches to center the wheels in the wheel wells so it will be OK. Got the u...
Thanks guys I looked them up in a Spicer catalog and chevy uses a Spicer 1310 but the mustang uses a Neapco 1-5900 found a combination U joint...
Also missing the front piece that clamps the u joint. I'm going to try to find a combination u joint to mate it to a drive shaft out of a 83...
Havent used this app before on my phone I have a 37 Pontiac coupe that I have repowered working front to back. Got to rear end that previous owner...
37 Pontiac
Well I'll give it a try [ATTACH] [IMG] EasyPezy
"Looks fantastic! I did not realize how many times I check the site until it was down." Me to! Avatars are bigger , but grainy, but take some...
Got a set coming, thanks again Hot Rust
Well I google 39 chevy checked 2 pages of links and found allot of old expensive ones, do you have a link for the ones in your picture
I just grabbed them out of the bucket sorry they aren't cleaned up better, I'm pretty sure this is the lower drivers door,37 Pontiac Coupe, any...
I need door hinges for a 37 Pontiac Coupe, I'm thinking any GM product of that year would work and possibly even earlier years. The car came with...
I have been following a number of threads on COE builds (customized bodies put on modern frames) but when I tried to post my next project 37...
Separate names with a comma.