The Jalopy Journal
Looking for a shop to send a friend to in San Antonio for mechanic work. 1977 Continental stopped running, he believes it’s something with the...
[ATTACH] [ATTACH] Trying to get some gears for what I thought was a 9”. I have always thought if you have to use a box wrench to remove the lower...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Putting up my 39 to see if there is any interest in it in these...
Wiring the car with a Bauer harness and I have two wires dumping out right next to this hole in the dash. I have the wire for the lighter below...
I would usually post something like this in classifieds, but it’s such a hard part to find I wanted to put the word out. Called all the Ford...
Finally got my 39 on the road after sitting on blocks since 1980, and had its first long drive, about an hour yesterday. Been driving around my...
Found a picture in the Hamb of a 1940 Ford. Does anybody know the owner so I can ask some questions about the wheel tire combination and stance....
I am looking for a 1957 Ranchero Bench Seat. Does a 58 or 59 bolt in a 57? I have located a 59 just don't know if it uses the same track. Floors...
does anybody know if a pitman arm from another vehicle that will work on a 55 car steering box that will give me roughly 1 inch drop. Don't want...
I have seen quite a few traditional fender less "A" Hot Rods using mechanical brakes, the vehicles were lowered by flipping the spring eyelets and...
Does anybody know who produced this frame for speedway? http://www.speedwaymotors.com/Model-A-Ultra-Low-Frame,42411.html Thanks[ATTACH]
My neighbor is in need of money and wants to sell his barn find 1950 Bel Air. This is a California car, has no rust in any of the floors, trunk or...
Building a 1927 Roadster truck. Because I want to drive this car A LOT when I am finished I need to have pretty good gas mileage, so I am torn...
Does anybody know or have attended any car shows in Japan. I would assume the Mooneyes is the largest but any information would be great! Thanks...
We are planning to move are manufacturing and distribution facility from CA to texas and need help. Here are some requirements.. -Are business...
Has anybody ever tried or in the process of cloning Cadzilla?
Looking at starting a new build...1940 Ford Truck. I want this truck to be a daily driver to replace my Ranger that currently gets 24 MPG. A buddy...
Getting ready to set up the steering on a 27t roadster pickup on a model a frame. I am trying to use as much original Model "A" frame parts as...
Does anybody know what kind of wheels these are? This car was built by Brizio. Here is the link to the build. This car was on the cover of "The...
Separate names with a comma.