The Jalopy Journal
Found this one on vacation a few years ago, it was in AZ somewhere. [IMG]
Any thermostat colder than 180 is a band aid and with a cooling system that is working anywhere near properly it will cause premature wear to the...
My compressor is in its own little room, it runs at a fairly low rpm and you can barely hear it when it kicks on in the shop. My little...
Yeah, the nv4500 is way more trans than I need for a 2wd truck. I have the nv3550 in my jeep and it is a nice shifting transmission with good...
I am getting ready to build an engine for a ad chevy truck this winter. I have a 77 350 long block I pulled from a truck at the junkyard. I was...
I always heat the bleeder with a torch a little before trying to remove them if they are stuck, always has worked for me.
Fill the float chamber with some gas and give the pedal a few pumps before you try starting it.
Nice thread hijack.
2003 jeep wrangler, I guess I'm not as old as you guys.
I have been wanting to find an AD chevy truck to work on this winter or spring. The year range for those style trucks is 47-55 right? I was...
I bought a hypertherm powermax 45 plasma cutter last year, well worth the $1500 I paid for it new. I cut 3/4 plate with no problem.
Fix the roof and keep it a coupe.
I like to use leaf spring bushings and dom tube for a sleeve. [IMG]
I wouldn't run the spark plug wires so close together.
That truck is awesome.
I have always wondered what made the cheap acorn lug nuts swell up. I would never put a capped or two piece lug nut on any of my vehicles, they...
I buy open ended lug nuts from summit, it cost me $25 to get 32 9/16 lug nuts for my jeep. They are open ended and seem to be good quality, they...
What's with the single shear a-arm bolts? You'd think for the price that they could come up with a better design.
I'm 15, I don't have any HAMB friendly rides but the next project I buy will be a 50s truck after I get my jeep done.
Thanks. I used a leaf spring bushing with a DOM sleeve for an isolator, then 1/4" 2x2 tubing to the frame. I plate the frame with 1/4 where the...
Looks good to me, here is how I mounted my 350. I know it's not HAMB appropriate but it's the same principle. [IMG]
I have a Hobart 187 and a Hypertherm Powermax 45 plasma cutter. I paid for them both by working, I'm 15 so it was an accomplishment for me. I...
[IMG]
You obviously don't live in the rust belt. Lot's of bolts snap or need heated to be removed in 10 year old cars around here.
I have a good machine shop about .5 mile from my house, everyone I have talked to says he does good work. So I took a steering knuckle over...
I love my Hypertherm Powermax 45, I have cut 3/4 without and issue. It will fly through 1/4 plate it you crank it up. Here it is sitting above...
Modified HF bead roller, used 3x3 .120 sqaure tubing. Next I need to make a guide for it. [IMG]
That's really good to hear is didn't go to the crusher.
[IMG] [IMG]
Just a small glimpse of the forgotten section of the junkyard. [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
Separate names with a comma.