The Jalopy Journal
Walt, That looks cool may have to come over and see it!!
Just a thought get a heat gun and point it on different areas of the radiator and engine to get a good idea wear the heat is. I found out that my...
I have seen them on peterbilt trucks
Just the body alone is worth that!! here in the great north east! I wouldn't think twice about it there are a lot of good looking mopar rods :) !...
Thanks for the video! saw my truck on the street cruising You did a great capturing the Lake George Experience Joe
I got the same problem with mine and it's a matched set. Took the sender out of the tank try adjusting it but still the same 1/2 tank reading.....
I got old stock radiator, that was just cleaned, getting a new 4lbs cap from Napa tomorrow, I guess you would call it a dump line on top of the...
I got a 4lbs cap ordered from napa, you stated getting the right cap at a lower pressure? Were you refering to the old stock caps or aftermarket...
The fan is mounted on the back( engine compartment area) pulling the air threw the radiator will have to check on rotation?? can you reverse the...
Just wondering who is going to this show this weekend? Always had a good time at this show. I got a show sticker!!:D so if all go's well I'll be...
Yes I'm running a electric fan, I have to agree with everyone on the thermostat. On my lunch I ran to Napa Got a 180% thermostat and ordered a...
I found a expansion tank that I can use so I"ll install That tonight and will look for the shroud that I had at one time maybe cut it down so I...
The radiator in my ford 1953 f100 is a stock truck radiator. The motor is a 302 ford vintage 1987, The truck was running hot so I just had The...
Man!! I wish I had that motor!! :)
Good luck with your projects! I have a 1931 plymouth pa , check out my posts and my friends 80% 0f them are early Mopar. Joe
Got the steering wheel assembly back together and by installing two split pins in the hub assembly the directionals are now shutting off after a...
Went over to advance on lunch, part number #1251670 87 ford 302 took the back plate off of it and with the heater and bypass connections...
Ok I checked my slips the water pump came from advance auto. The Part is #1251670 listed for a 87 ford 302
Good morning!! I have a 302 ford motor that I installed in my 1953 ford f100 pickup. I rebuild the motor and had problems at first with the...
I got the adapter off and on the back side there are two small holes in close near the shaft spline area. Located on the flat part of the copper...
I have a 1966 ford galaxie steering column with a Lecarra steering wheel and the adapter for it in my 1953 ford f100. The horn button works but...
Your pictures are great!! We went for the day on saturday,Got there at 8:30 in the morning stayed till 4:00. Makes for a long day, and yes on not...
Cool!! :):)The show was good but hot !! There not to many places to get out of the sun sitting areas are limited. I didn't see to many people...
Cool pictures thanks for adding !! Joe
Here is a link to some pictures I took at the syracuse car show a general mix and a few different one's Joe...
Going out saturday will get there early and spend the whole day.
Happy Birthday Jeff! :)
The car looks great!! I think the chop makes it! keep up the good work! mine still in the holding pattern. Joe
My model A is all stock with fenders. There are some pictures of it in my profile not shure how to load them to this post.The stock shocks are...
Good morning! Looking for pictures or fabrication information and shocks style used for installing a new style setup for my model a. Right now I'm...
Separate names with a comma.