The Jalopy Journal
I posted a thread about this design before. Not much interest. I have better pics now. I hope it is of interest as it really works great and is...
I have a nice Hollywood tag light. It has some thin primer paint on it that lacquer thinner will not remove. I assume that it is epoxy. What can I...
I have a method of checking backing plates for warpage. The stuff is old and can get bent. I attach a strap to the hub and measure thru a hold in...
I have an old sofa. It is a very expensive top of the line big sofa. The leather is still in fine shape. I believe the leather could be used for...
Very nice coupler. There are a couple of small worn spots on one of the halves where something got in it during installation. The inner cone and...
Extremely nice aftermarket U-Joint. I can not detect any clearance at all in the joints. It has a little surface rust. A Evap O Rust dip or just a...
These fit the 315/325 Dodge hemi and polly engines. They also fit the 330/341 DeSoto hemi and polly engines. They are .010 oversize. They are...
Delete
Cancel
New Old Stock!! Never a bolt in it. Look at the pics with bolt holes and see no witness marks. Adapts the Y block 54-64 Ford engines to the early...
delete, double post
[ATTACH] I have used this design on every car since 1965. Works great. It has been on my roadster since built. Maybe 200K miles. The 3W before...
delete
I think this carb was professionally restored. It came to me as shown. It has had wonderful work done to it. It is completely cleaned and has a...
Looking for who is recommended to resurface lifters.
Nice old valve spring compressor. Made by Landis. Works fine. It works by putting the tool under the spring and squeezing. You move the pawl to...
A tool from way back to set flathead valves. It bolts on where the distributer mounts and shows which cylinder to set the valves on. It fits the...
Old aftermarket fuel mixture adjusting fittings for Stromberg 48's. 97's, 81's, etc. They go in the holes where the plugs for the jets go. The...
Rebuilt excellent 8BA carb. Used 49-51. It is as clean as it can possibly be. I took the top off and looked inside. Looks brand new clean. I did...
Old Flathead valve guide pry bar. Some slight wear. No damage that mounts to anything. Not rusty or bent. No brand but was something on one end...
I was setting the toe-in on the roadster and thought I would share how I do it. I have no idea how most people do it. I tried measuring from tire...
I am trying to install some Lincoln brakes. My existing hoses have wheel side fittings of 3/8. The wheel cylinders are 7/16 I would rather buy...
Old chrome shock links. The Green book says 28-34. I took them off the front of my 32 5W. They have chrome loss and no bushings....
Separate names with a comma.