Technical Flathead v8 manifold vacuum ports

Greetings,
I have a question about a 1933 OEM intake manifold I purchased (#40- 6520). This intake
has 2 vacuum ports on it and I just wanted to
verify that 1 of the ports went to the vacuum
brake on the distributor and possibly the other
to a wiper motor?This is a 33' to 36' motor and
it will be basically stock. It will also have 1 Stromberg 97 carb on it. This motor will go on
a test stand eventually and not directly in an
automobile. Any info would be much appreciated.
Thankyou!

 

You have it right.

 

OK Very good. Thank you for the
verification 42 Merc. Best regards
Chuck1957

 

i was told, below the butter fly's is full vacuum. above is light vacuum.

 

Yes that make sense...... I agree, but on
this particular manifold the vacuum ports are the same height down by the intake manifold bolts which I would take to be
full vacuum from both? I don't have any avenues for vacuum around the Stromberg 97 carb. Thanks!

 

>>>I don't have any avenues for vacuum around the Stromberg 97 carb. >>>

I use a homemade hardwood spacer drilled for 1/4" port & tee on my 21-studder for brake & wipers. Plug the two dinky manifold ports.

 

That's an interesting way to go about it.
I will definitely take that under advisement. Thanks Jack!