Looking for input on where to mount the seatbelts on a 1941 Chevy Tudor Sedan. Has anyone installed them? What length did you use? -VOH
I did it on my 40 coupe, just went to a yard and used a stock gm retractor/belt type setup. Bolted it to the seat anchors (I used bucket seats though, you might still have the bench type). Didn't use the 3 point, just the old style belt/buckle.
My avatar 41 olds I used 60 inch belts straight seat I bolted through the floor to a 4ich wide by 3/8 thick by width of floor flat stock, for sure this is overkill but when I did it steel was cheap now it would be pretty expensive. Couple of friends bolted theirs to the frame with square stock. I think anything would be better than just bolting to the floor with a big washer but I’ve seen that done also.