Hot Rods 1946 Ford Hot Rod Works Pinion Seal

My friend has a 46 Ford rear axle that has a Hot Rod Works open drive pinion adaptor fitted. Now he needs a new oil seal and was wondering if anyone has a cross reference number for the seal which is stamped USA CR2106. Thank You.

 

When I had my '42 PU, I found one at Mac's as I recall.

 

Have you tried calling Hot Rod Works? I had problems locating a wheel seal for a FatMan front end. One call and I got the correct part number.

 

Or any bearing supply house should be able to cross reference a CR2106...

 

X2, or just call Hot Rod Works. Either way should be successful getting a replacement seal.

Sent from dumb operator on a smart phone

 

Thanks for the replies guys. The guy has tried bearing shops here in the UK for a cross reference with no luck. What makes it hard is that the seal was damage getting it out so cannot take any measurements. So it looks like he will have to get one from the Hot Rod Works.

 

You might have a number missing?
https://www.skfextranet.com/crsealsfinder/

 

Can you take measurements from the pinion yoke and the housing?

 

The installation sheet posted on their website says its CR 19832.
https://www.hotrodworks.com/wp-content/uploads/2015/03/1105-1106-installation-instructions.pdf

 

Thanks for all you replies guys I knew I could rely on you for an answer. Here has found a bearing supplier to get them for him the downside they have told him they have to come from the States and it will be 11/ 12 weeks. I have found someone here that have got then.
alchemy that is what I have ask him to do

 

https://simplybearings.co.uk/shop/p...haft-Seal-2x2.75x0.313-inch/product_info.html

Just verify measurements listed with those from your damaged seal.

 

Algoma thanks for that.

 

Here it is on Amazon. https://www.amazon.com/19832-Double-Rotary-Shaft-Seal/dp/B00RW791UY

 

I wasn't sure how Amazon shipping was to UK, so looked for UK supplier.