Hey guys, I need some help finding a pressure plate, it looks like a GM bolt pattern, the bolt pattern being symmetrical at 5-3/4, 10.5 disk service and the hard part is the Diaphragm center opening is 2.750 .. The one I have here in the picture came from a Flathead car, mounted to a Ram Clutches Aluminum Flywheel, cant find one anywhere with the 2-3/4 center ...
Hey Mark, you can get what you have rebuilt. Call Dallas Differential & Gear or Wade Transmission & Gear. They should point you in the right direction. WPT in Wichita Falls rebuilds pressure plates, & clutches .. but you shouldn't have to go that far. They'll measure your spring rates, & disassemble what you have, & put it back the way it was sold or better. Car weight, power, driving habits etc.
Contact Ky Clutch 502 955 9173 250 Gun Club Road Brooks Ky 40109 I bet they either have what you need or can rebuild whut you got............. Might email those picture to them www.kyclutch.com
Pretty sure that's the set up from that Hot Rod magazine article from the 90's on getting the best standard set up for a flathead to later model clutch set up to ease the stiff set up from fomoco......think I lost that mag in in the fire mess.......
I've sent to Fort Wayne and clutch https://fortwayneclutch.com/ a few times, they are pretty danged good
well shit, im not having much luck, no one seams to have the larger center, ive ground one out before, guess ill do it again ... thanks for the try guys ..