I just had a good friend give me a pair of leaf springs marked 35 to 48. He gave them to me as I plan on putting parallel leaves on my 35 coupe. But I have none of the frame mounting brackets to install the springs. If I knew who made them I might know where to go for the kit. One end has a bushing, the other does not, and the only markings I can find is on the Spring clamps it says Betts. Now the Internet tells me Betts is a spring manufacturer, but I’m sure these were part of someone’s kit. They also have anti-squeak pads built-in. Sent from my iPhone using The H.A.M.B. mobile app
Measure the springs. If the eye to eye measurement is a nominal 48" and the dimension from the bushed end to the center bolt is a nominal 24", with the width at 2-1/2" , Then a Chassis Engineering or a TCI mounting kit would work. The bushed end goes forward.
47-1/4 is what I get. Thanks 42Merc! Looks like that is what I have, a little over 24” to center. Sent from my iPhone using The H.A.M.B. mobile app
If the other dimensions are close, the mentioned kits will work. I believe the spring manufacturers use broken yardsticks for measuring. My TCI springs measured about that. Plus the center bolts varied a 1/4" .
Betts Spring Mfg./ 2843 S. Maple Ave. / Fresno, CA 93725/ 559-540-8265 I hope that's enough, & no, I don't know the foreman's name. LOL!