New lower metal shaped on the power hammer and grafted in. need help, skilled metal workers,$25ph and upwards depending on skill level reply with resume to [email protected]
I used metal cut from the roof of a parted out VW squareback. Good German steel and it had just the right amount of crown to match the bottom 5" of my '40 GMC/Chevy doors. Your template is good, When I chopped the top on mine I found the left and right contours from the door jamb the the back window were far from the same, (about 3/8" different radius!) so I made one for each side.
tacked into position and ready to hang the door on the cab for a test fit for gapping before we go any further. need help, skilled metal workers,$25ph and upwards depending on skill level reply with resume to [email protected]
and finished.. need help, skilled metal workers,$25ph and upwards depending on skill level reply with resume to [email protected] .