Getting all ready for the jalopy showdown this weekend, going over the truck with a fine tooth comb. I wanna do all i can to hopefully make sure there are no issues. Truck seems to be running good. But i have a question on the 3 bolts around where the torque tube enters the rearend. I havent had this apart, but i would imagine they would set a bushing or bearing. My question is, what should they be set at? Or is a adjust, drive it, adjust, drive it, adjust till you get no vibration or noise? I have no noise, i just would like to be sure they are set to correct specs. Thanks for any information! I appreciate it.