The Jalopy Journal
Can't resist a comment! Obsession! Got to have it if it ever is going to materialize into reality. Yeh, there are times when you have to just...
Wipers pivoted off the cowl always improves the looks compared to the swinging type.
" Do you like 'em all?" This is one that looks right. The short wheelbase is cool. Howbeit, T-buckets do have a harsh ride. The "W" looks like...
I wrap an electric heating blanket around the battery during winter. Draws very little house current to keep the electrolyte warmer than ambient....
The 324 firing order: 1-8-7-3-6-5-4-2! Sounds like you got it right. And that QC sings.
Hard to determine the front axle, but is does not look dropped! The "T" did not have deep crown fenders so you could not hide the tops of your...
Totally agree with Jive! Stance was perfect.
I see some Kraut in that front end!
Thank you, lodaddyo
lodaddyo, where were you able to buy the "axle" bearings from?
Harmonic balancer must be co-ordinated with the correct tab. The balancer inertia ring must not have slipped and must be in its stock location...
If you are using silicone based brake fluid, and some of that gets on the friction material, you end up with no braking action on that side (in...
The earlier 324 camshafts will not fit the '56 324 engine. They used the larger journals like the 371s.
Actually, my alignment device is far more intricate! Requires cutting apart a 3rd member in order to access the carrier bearings. Then all...
Gimpy makes a superb point: timing curve! It takes a good technician on a chassis dyno to properly dial in the ideal advance curve for your...
Separate names with a comma.
The Jalopy Journal