The Jalopy Journal
Are there different sizes for flathead transmission bolts? I have a 59a motor with 7/16 threads in the block and sump, but the bolts won't fit...
How much caster are you guys getting with this setup? I've got mine mocked up at 5 degrees and it's sitting way lower than the ones pictured. I'm...
I'm in the process of pulling apart my '37 Lasalle box. I've got the cluster out and the input shaft bearing out, but now I can't get the synchro...
I don't know of a rebuild kit, but you can buy the bearings new, and gasket kits are available too. Have a look in the tech archive. I think...
Never mind. 48.5" if anyone else is doing it. Should be enough room for the brake fittings, and I think the shackle preload came out pretty good.
Getting set to put the perches on my diff, but I am reading conflicting information about how far the perches should be set apart. Has anyone...
Thanks. What will the ratio be like? Too slow?
Right sector is mine, left is Ford car. Spline measures 0.125".
Hex nut. The hex from my box fits the Ford car box.
Maybe COE? Larger truck maybe? I'm clutching at straws here. The box looks great and will work for my build. But it's useless without a pitman arm.
Not F100, it's splined just like 37-48 car ones, but slightly larger. I have an early f100, and 40 Ford passenger car box to compare. F100 is a...
I have what I think is a mid 40's ford truck steering box. It's push-pull steering, but not an F1. The internals are identical to the F1 design,...
Separate names with a comma.