The Jalopy Journal
Well, after checking with a couple of the biggest shock vendors, I had no luck. Will just be going with plain painted shocks. It might have been...
If I had any idea what car used them I would follow that. Its a mix of '46 Studebaker coupe with boxed frame and '37 Willys axle.
Have been looking all over, so far unable to locate any pin mount (threaded) by pin mount chrome or stainless front shocks. I have found some...
Thanks for taking time to reply, and include photos.
Oh crud. Was wanting to use a length of tube with saw cuts in it. Thanks.
Wanting to hear actual experience of you who have installed a PCV valve in your intake manifold, without any baffle underneath the PCV valve. I...
Ugh! I jut threw away a big scrap of it! Tks for the tip.
Well, I thought the rubber sheet I cut them from was EDPM material, but the gasket poor performance now has me wondering if it really was. I...
I made some hard to find flat gaskets out of sheet rubber for my wiper bezels and external hood latches. After a few years, they are cracked and...
What is your engine and transmission setup?
Thanks, good advice.
1946 Studebaker coupe. Occasional drive/cruise, but wont be beating on it. Will open it up to hear it through the gears every now and again. Will...
Separate names with a comma.
The Jalopy Journal