The Jalopy Journal
I've ran one a long time like that and it hasn't caused any problems.
If ya have enough kids you can put a mattress behind the seat and put a couple back there for long trips. I've ridden a lotta miles behind the...
usually set the toe to 1/8", I think this is to allow for the spread that occurs when the slack comes out of all the joints tying the 2 wheels...
I'd say it's a fuel delivery problem. has the car been setting a long time? You might wanna try blowing back thru the gas line to the tank....
Make sure , let me say that again. Make sure that all of the butterflies are closed when it's supposed to be at idle. with the engine not...
Has it stuck in the last month it's been sitting around or has it been locked up for a long time. After checking the other things mentioned take...
I've been running one in a 385 for 12 years, no problems
4 1/8" stroker, 3 3/8" pistons, MCF cam 21a rods Offy heads, Headers, Mallory electronic Distributor.MCF oil pump, adjustables, Uncle Max's 97's...
I ran 2 x 2 for a long time ran great and fairly economical. Put 3 97's on with straight linkage. It was like adding half another motor to it....
Dammit man, I have trouble stompin a beer can flat! That is awsome work.
sounds like screwdriver to me
You'll have a lot easier time setting it up with straight linkage. Just be sure that you have all the butterflies closed and all of the throttle...
I put a blower motor out of a cutlass in my heater. Had to change the fan best I remember, wasn't too much trouble.
NRchopshop I ran mine under but that isn't the way it should go. I'm pretty certain that it should be ran above the clutch crossover peice . I...
couldn't rotate the diff. a little to line it up?
Separate names with a comma.