The Jalopy Journal
I haven't done it, but I read on here awhile back that stock jeep TJ (1996-2006) coils lower the rear 2". If you look on craigslist you could...
I have never used Rust Mort. But I have had great luck with Ospho. Loctite makes some neutralizer in an aerosol can that works pretty decent. Its...
Close, 1975 was the first year. I have an integral head 250 out of a 75 nova with a cracked head sitting on the floor of the shop at the...
I suggest slowing down too. Really pay attention to your puddle.
Just out of curiosity, are you pushing or pulling the weld?
http://www.jalopyjournal.com/forum/threads/hurst-dual-pattern-with-synchro-lock.428340/ I don't quite know if this is what you are looking for,...
I am going to preface this with saying (as a couple people have said earlier in the thread) There really is no winner in the solder vs. crimp...
They just hired a guy at work fresh out of uti. From the looks of it they don't teach you a whole lot. Try a community college program or something.
Chrysler electrical classes tell us to use a w crimp then solder over it. Weird because evidently OEMs don't solder anything.
Hmmm, I have a 75 nova with a 250 and HEI in the drive way and a 235 on an engine stand. haha. One thing I will say is that the coil/module on...
I read an article one time that showed how to install an aftermarket unit into a factory case. I'll see if i can dig it out.
69 degrees with 55% humidity right now. I feel sorry for all you guys. Haha.
I can vouch for this. Haha. I used JB weld on mine as well. I its Not 100% done yet. Have to some finish work still but its 100 times better than...
If i was closer i would help you scan them. I have an epson 4490. Best scanner for the money. Its only about $30 more than the wolverine one that...
I know this has been talked about before and i have searched, but I haven't really found a comparison between products. So I have been getting...
Separate names with a comma.